The L298 Stepper Motor Driver Board Module For Arduino/Raspberry-pi/Robotics, using ST L298 chip can directly drive two DC motor, and provides a 5V output interface, support 5v and 3.3V MCU control, you can easily control the DC motor speed and direction, you can also control the 2-phase stepper mot..
ROBOMART makes a low-cost relay board shown above that contains both the relay and the required driver circuit built using a discrete transistor. The relay coils on this relay require around 6VDC. It is easier to drive relays like this that use a lower coil voltage. The relay can switch up to 220VAC..
This is a High Torque DC Motor 3500 RPM. It is most suitable for light weight robot requiring small power. This motor can be used with 69mm Diameter Wheel for Plastic Gear Motors and 87mm Diameter Multipurpose Wheel for Plastic Gear Motors. A DC motor is a mechanically commutated electric motor powe..
Chassis Board is the mechanical frame structure of the mobile robots. It should is the backbone of the robot. We arrange/connect everything like motors, sensors, wheels, development board, studs, clamps , screws, etc. of the robot to it.It give us the base to build our robot and allow us place our c..
A DC Geared motor is a simple DC motor with gear box attached to the shaft of the motor which is mechanically commutated electric motor powered from direct current (DC). This DC geared motor is centered shafted metal type motor having 150 rpm.Features of 150 RPM Center Shaft Metal Gear MotorGear mat..
This is a high torque DC gear motor providing 32Kg-cm torque. The motor generates a low RPM which is very ideal for making gripper to pick and place heavy objects with greater accuracy.Features of 150 RPM High Torque 12 Volt DC Gear Motor:150RPM 12V DC motors with Metal Gearbox and Metal Gears.18000..
This is fully programmable 30A BLDC ESC Circuit with 5V, 3A BEC. Can drive motors with continuous 30Amp load current. It has sturdy construction with 2 separate PCBs for Controller and Electronic Speed Controller power MOSFETs. It can be powered with 2-4 lithium Polymer batteries or 5-12 NiMH / NiCd..
This is fully programmable 20A BLDC ESC with 5V, 3A BEC. Can drive motors with continuous 20Amp load current. It has sturdy construction with 2 separate PCBs for Controller and ESC power MOSFETs. It can be powered with 2-4 lithium Polymer batteries or 5-12 NiMH / NiCd batteries. It has separate volt..
The L298 is an integrated monolithic circuit in a 15- lead Multiwatt and PowerSO20 packages. It is a high voltage, a high current dual full-bridge driver designed to accept standard TTL logic levels and drive inductive loads such as relays, solenoids, DC and stepping motors. Two enable inputs are pr..