Programmers
SKU: RM000082
The ATMEL 89C2051 Microcontroller or commonly known as AT89S52 is a low-power, high-performance CMOS 8-bit microcontroller with 8K bytes of in-system programmable Flash memory. The device is manufactured using Atmel’s high-density nonvolatile memory technology and is compatible with the industry-sta..
₹ 70.80
(inc GST)₹ 60.00 ( + 18.00% Gst Extra )
SKU: RM000021
Atmega-16/32 Project Development Board is a complete starter kit and development system for the AVR Atmega16 microcontrollers from Robosapiens. It is designed to give designers a quick start for interfacing of i/o peripheral devices.Features of ATMEGA 16 Project Board Without Controller V 1.0ATMEGA ..
₹ 141.60
(inc GST)₹ 120.00 ( + 18.00% Gst Extra )
-40 %
SKU: RM001122
The PIC Standalone + ICSP Serial Programmer for PIC microcontroller is a highly useful low cost PIC programmer. As the name indicates it is interfaced via serial port. Using this you can program 8-pin, 18-pin, 28-pin,40-pin micro controllers. It supports almost PIC12XXXX, PIC16XXXX, and PIC18FXXXX s..
₹ 352.82 ₹ 590.00
(inc GST)₹ 299.00 ( + 18.00% Gst Extra )
SKU: RM000945
The ATMEGA32U4 is an Arduino Esplora micro-controller board derived from the Arduino Leonardo. The Esplora differs from all preceding Arduino boards in that it provides a number of built-in, ready-to-use set of on-board sensors for interaction. It's designed for people who want to get up and running..
₹ 2,830.82
(inc GST)₹ 2,399.00 ( + 18.00% Gst Extra )
-15 %
SKU: RM000592
This is an atmega 8 project board without microcontroller specially used for the purpose of project designing.Features of Atmega8 Project Board without Controller V2.0:Onboard atmega 8 IC base.Onboard crystal oscillator.Onboard I/O peripheral pins.Onboard On board PBT connector.Onboard DC socket.Onb..
₹ 129.80 ₹ 153.40
(inc GST)₹ 110.00 ( + 18.00% Gst Extra )
SKU: RM000020
Atmega-8 Project Development Board is a complete starter kit and development system for the AVR Atmega8 microcontrollers from ATMEL ® Corporation. It is designed to give designers a quick start to interface I/O peripheral devices easily.Features of ATMEGA 8 Project Board without Controller V 1.0ATME..
₹ 116.82
(inc GST)₹ 99.00 ( + 18.00% Gst Extra )
-24 %
SKU: RM001123
This AVR Parallel Port Programmer can be used for in-system programming for Atmel ISP programmable devices. The programming interface is compatible to STK200 ISP programmer hardware so the users of STK200 can also use the software which can program both the 8051 and AVR series devices.Features of AV..
₹ 223.02 ₹ 295.00
(inc GST)₹ 189.00 ( + 18.00% Gst Extra )
-30 %
SKU: RM001120
The AVR Serial Programmer simple COM PORT based AVR at-mega Programmer will allow you to easily transfer hex programs to most ATMEL AVR microcontrollers. It is more reliable than most other simple AVR programmers available out there and can be used without a usb port.Features of AVR Serial Programme..
₹ 223.02 ₹ 318.60
(inc GST)₹ 189.00 ( + 18.00% Gst Extra )
-33 %
SKU: RM000008
AVR USB programmer is an in-circuit programmer for Atmel AVR controllers. The programmer uses a firmware - only USB driver; no special USB controller is needed.It is complete solution for programming popular AVR series of micro controllers with ease. It can be used with Low Cost ATmega development b..
₹ 234.82 ₹ 352.82
(inc GST)₹ 199.00 ( + 18.00% Gst Extra )
SKU: RM001048
As the name suggest AVR multi controller programming board is design to program the different series of AVR microcontrollers. This AVR multi controller programming board is very simple in design and easy to use. By the use of this board there are 2 ways to program your microcontroller. We are provid..
₹ 116.82
(inc GST)₹ 99.00 ( + 18.00% Gst Extra )
SKU: RM009601
ST-Link V2 Programmer For STM8 and STM32 is fully consistent with the official version, support for automatic upgrades, support the full range STM32 SWD (only 4pins including SWCLK, SWDIO, and power) and a full range STM8 SWIM (only 4pins including SWIM, Reset and power) download and debug.Use this ..
₹ 234.82
(inc GST)₹ 199.00 ( + 18.00% Gst Extra )
SKU: RM000032
Dual H-Bridge Power Transistor Motor Driver Arduino Board is a simple motor driver used to drive high power dc motor which is both the combination of two NPN & PNP (TIP-122 & TIP-127) transistors to operate dual motor at a time in bidirectional.Features of Dual H-Bridge Power Transistor Moto..
₹ 411.82
(inc GST)₹ 349.00 ( + 18.00% Gst Extra )
SKU: RM002511
CAN is a multi-master broadcast serial bus standard for connecting electronic control units (ECUs). Each node is able to send and receive messages, but not simultaneously. A message consists primarily of an ID (identifier),which represents the priority of the message. A CAN message that is transmitt..
₹ 6,406.22
(inc GST)₹ 5,429.00 ( + 18.00% Gst Extra )
SKU: RM002353
..
₹ 1,060.82
(inc GST)₹ 899.00 ( + 18.00% Gst Extra )
SKU: RM002255
1.Support the full range of STM32 SWD interface debugging, simple interface (including power supply), 4 line speed, stable work; Interface definition shell directly address! Don't need to read instructions.2.Support all series STM8 SWIM download debugging (common development environment such as IAR,..
₹ 211.22
(inc GST)₹ 179.00 ( + 18.00% Gst Extra )
SKU: RM002253
..
₹ 541.62
(inc GST)₹ 459.00 ( + 18.00% Gst Extra )
-50 %
SKU: RM000894
The SMD TQFP package type ATMEGA 8 is an 8 bit microcontroller with 32 pin used in vast area.Features of ATmega8 SMD TQFP Package:131 powerful instructions – most single clock cycle execution32 × 8 general purpose working registers8 Kbytes of in-system self-programmable flash program memory512 bytes..
₹ 106.20 ₹ 212.40
(inc GST)₹ 90.00 ( + 18.00% Gst Extra )
SKU: RM003239
This shield kit pack will allow you to turn any Arduino into an AVR chip burner! It is specifically designed for people who want to program Atmega328P's to turn them into Arduino bootloader chips using an AVR-ISP sketch, but it can also be used to make a 'standalone' AVR ISP programmer - so that you..
₹ 3,097.50
(inc GST)₹ 2,625.00 ( + 18.00% Gst Extra )
SKU: RM003205
The Particle Shield Shield converts the footprint and pins of your Photon into that of an Arduino, allowing for use of existing Arduino shields and accessories.This shield converts the pin mapping of the Photon to the Arduino pin layout and provides a voltage translation of 3.3V to/from 5V. Note tha..
₹ 2,948.82
(inc GST)₹ 2,499.00 ( + 18.00% Gst Extra )
SKU: RM003204
he new and improved Programmer Shield is essentially a USB-JTAG converter that gives advanced users complete access to the Photon's memory space. It supports openOCD and the WICED SDK, and is built around the FT2232H high speed USB FIFO.Unlike the previous Programmer Shield, it is fully standalone a..
₹ 4,718.82
(inc GST)₹ 3,999.00 ( + 18.00% Gst Extra )