Generic

The resistor array is a passive nine-terminal electrical component that serves as eight 10K ohms resistances and one common ground.Features of 10 Kilo Ohm Resistance Array/Network:Resistance: 10k.Wattage: ¼ watt.Ease of embedding.Applications of 10 Kilo Ohm Resistance Array/Network:DIY projects.Ardu..

5V 10A SMPS - 50W - DC Metal Power Supply - Good Quality - Non-Water ProofSpecifications:Input Voltage: AC 100 - 264V 50 / 60Hz Output Voltage: 5V DC, 10AOutput voltage: Adjustment Range: ±20% Protections: Overload / Over Voltage / Short Circuit Auto-Recovery After Protection Uni..

This is General purpose 9V Original HIW marked Non-Rechargeable Battery for all your project and application needs. As we experienced the use of this battery in our testing lab for various purpose, we can assure you the best quality, long life and genuineness of this battery among all options availa..

This is General purpose 9V Original HW marked Non-Rechargeable Battery for all your project and application needs. As we experienced the use of this battery in our testing lab for various purpose, we can assure you the best quality, long life and genuineness of this battery among all options availab..

The LED matrix module is a display device which is used to display both Static and Dynamic Information. It is a 8X8 matrix display device which can also multiplex with more than one LED module.Features of Led Dot Matrix Module With Display ControlEasy to interface.Serial data interface.Less power co..

The RF transceiver (Both transmitter & Receiver) module is a wireless remote control module which both can transmit and receive the RF Signal.Features of 433 Mhz RF Transmitter And Receiver:Frequency: 433.92 MHZ.Operating voltage: 3-12 vdc.Data rate: up to 8 kbps.Works with HT12E or other decode..

This is an easy to use voice recognition module which communicates over UART protocol with the processor/controller board. 15 Voice commands can be stored in the memory of this voice recognition module and it will detect the voice whenever the same sound is captured by the microphone. The module is ..

The 10 kilo ohm Potentiometer is a three terminal variable resistor which is used to vary or change the resistance. It is normally used to control any deviceFeatures of 10K Potentiometer:Low temperature coefficient.Lower noise.Tighter resistance tolerance.Long-term resistance stability.Applications ..

The L298 Stepper Motor Driver Board Module For Arduino/Raspberry-pi/Robotics, using ST L298 chip can directly drive two DC motor, and provides a 5V output interface, support 5v and 3.3V MCU control, you can easily control the DC motor speed and direction, you can also control the 2-phase stepper mot..

This is a Pyrolectric sensor(PIR) module which developed for human body detection.Its is also called Motion Sensor.A PIR detector combined with a Fresnel lens are mounted on a compact size PCB together with an analog IC , and limited components to form the module. It detect the motion by detecting t..

33pF/0.033nF/0.000033uF 330 Ceramic Capacitor (Pack of 20)A ceramic capacitor is a fixed value capacitor in which ceramic material acts as the dielectric. It is constructed of two or more alternating layers of ceramic and a metal layer acting as the electrodes.Features of 33pF/0.033nF/0.000033u..

This Sound Sensor is a simple microphone transducer based sensor based on the Transistor Amplification which converts from sound energy into electrical energy, and it can be used to detect the sound strength of the environment. The value of output can be adjusted by the potentiometer.Features of Sou..

A multimeter is a combination of a multirange DC voltmeter, multirange AC voltmeter, multirange ammeter, and multirange ohmmeter. An un-amplified analog multimeter combines a meter movement, range resistors and switches.Features of Multimeter:Voltage, alternating and direct, in volts.Current, altern..

A 35 Watt Soldering Iron is a hand tool used in soldering. It supplies heat to melt the solder so that it can flow into the joint between two work pieces. A soldering iron is composed of a heated metal tip and an insulated handle.Features of Soldering Iron 35 Watt – Tony:Technically advanced cartrid..

Glue sticks are solid adhesives in twist or push-up tubes. The user can apply glue by holding the open tube, thus keeping their fingers clean. Because of their ease of use, and their economic value, glue sticks are a popular school and office supply. Glue sticks are designed to glue paper and card t..

The AC adapter, AC/DC adapter or AC/DC converter is a type of external power supply, often enclosed in a case similar to an AC plug. Other names include plug pack, plug-in adapter, adapter block, domestic mains adapter, line power adapter, wall wart, may be described as chargers. AC adapters are use..

XBee or Zigbee adapter board is used for interfacing XBee wireless module combining both transmitter and receiver on any prototyping board with ease. It has onboard 3.3V low drop voltage regulator and LED indicators for RSSI, Associate and Power. Connections to all pins of the Zigbee wireless module..

A screwdriver is a hand-tool for turning screws. A typical screwdriver comprises an approximately cylindrical handle of a size and shape to be held by a human hand; an axial shaft embedded in, and protruding from, the handle; and, a tip found at the end of the shaft, opposite the handle. The handle ..

This is a light weight continuity tester designed to check the connectivity between two points in a PCB.Features of Electronic Continuity Tester:Economical cell-Consumption.Continuity check of House Hold & Industrial Equipments.Can test Diode for open short.Can test transistor for open/short &am..

The 7-segment display, also written as “seven segment display”, consists of seven LEDs (hence its name) arranged in a rectangular fashion as shown. Each of the seven LEDs is called a segment because when illuminated the segment forms part of a numerical digit(both Decimal and Hex) to be displayed. A..