Generic

2N6344 TRIAC is the primary design for full‐wave AC control applications such as light dimmers, motor controls, heating controls, and power supplies or wherever full‐wave silicon gate controlled solid‐state devices are needed. Triac type thyristors switch from a blocking to a conducting state for ei..

2N6342 TRIAC is the primary design for full‐wave AC control applications such as light dimmers, motor controls, heating controls, and power supplies or wherever full‐wave silicon gate controlled solid‐state devices are needed. Triac type thyristors switch from a blocking to a conducting state for ei..

FeaturesTwo Current Controlled Amplifiers with Differential InputsExcellent Matching Between AmplifiersLinearizing DiodesControlled Impedance BuffersHigh Output Signal-to-Noise RatioIdeal for Current Controlled Amplifiers, Filters and Oscillators..

2N6071 TRIAC is the primary design for full‐wave AC control applications such as light dimmers, motor controls, heating controls, and power supplies or wherever full‐wave silicon gate-controlled solid‐state devices are needed. Triac type thyristors switch from a blocking to a conducting state for ei..

FeaturesHigh-Speed Operation and Low Power RequirementsInput Offset Voltage: 0.2 mVInput Offset Current: 30 nAHigh Gain Bandwidth: 10 MHzSlew Rate: ±12V/µsLow Supply Current: 360 µA / AmplifierWide Supply Voltage Range: ±2.7V to ±24V..

FeaturesLow Noise, High Speed and Wide Bandwidth Op-AmpInput Offset Voltage: 0.3 mVWide Bandwidth: 25 MHzHigh Output Current: ±40 mALow Harmonic Distortion: 0.0015%Supply Voltage: ±5V to ±18V..

FeaturesDesigned for Low Noise, Low Drift and Accurate Closed Loop Gain ApplicationsInput Offset Voltage: 0.5 mVInput Offset Current: 2 nAHigh Open Loop Gain: 3,000,000High Common Mode Rejection: 120 dBSupply Voltage: ±3V to ±22V..

The 5P4M and 5P6M are a P gate all diffused mold type Thyristor granted 5 A On-state Average Current (TC = 103°C). Features:- Easy installation by TO-220AB package. 80 A surge current. High Voltage: VDRM, VRRM = 400 V (5P4M) : VDRM, VRRM = 600 V (5P6M) Application:- Mot..

The 3P4MH 3A Thyristor is P-gate fully diffused mold SCRs with an average on-current of 3 A. The repeat peak off-voltages and reverse voltages are 400 V and 600 v.3P4MH Key FeaturesA small and lightweight package TO-202AEasy to handle even on the mounting surface due to its TO-202A dimensionsProcess..

The 2P4M 2A Thyristor is P-gate all diffused plastic molded type SCR granted average on-state current 2 Amps (Tc = 77 C), with rated voltages up to 600 volts.FeaturesPeak Reverse Voltage (Vrsm): 500VPeak Off-State Voltage(Vdsm): 500VOn-State Current (It): 2.0AGate Trigger Current (Igt): 200µAGate Tr..

TYN812RG SCR series is suitable to fit all modes of control, found in applications such as overvoltage crowbar protection, motor control circuits in power tools and kitchen aids, inrush current limiting circuits, capacitive discharge ignition, and voltage regulation circuits. Available in through-ho..

..

TYN612RG SCR is suitable to fit all modes of control, found in applications such as overvoltage crowbar protection, motor control circuits in power tools and kitchen aids, inrush current limiting circuits, capacitive discharge ignition, and voltage regulation circuits. Available in through-hole or s..

FeaturesDesigned for Wide Bandwidth and High Slew Rate ApplicationsUseful in A/D Converters, Oscillators, Active Filters etcInput Bias Current: 250nASmall Signal Bandwidth: 15MHzSlew Rate: 50 V / µsSupply Voltage: ±5V to ±20V..

TYN412RG SCR is suitable to fit all modes of control, found in applications such as overvoltage crowbar protection, motor control circuits in power tools and kitchen aids, inrush current limiting circuits, capacitive discharge ignition, and voltage regulation circuits. Available in through-hole or s..

FeaturesPeak Reverse Voltage (Vrsm): 600VPeak Off-State Voltage(Vdsm): 600VOn-State Current (It): 4.0AGate Trigger Current (Igt): 200µAGate Trigger Voltage (Vgt): 0.8V..

T106D1 4A 400V SCR semiconductor is a half-wave unidirectional, gate-controlled rectifier (SCR-thyristor) that complements Teccor’s line of power SCRs. This group of packages offers ratings of 0.8 A to 10 A, and 200 V to 600 V with gate sensitivities of 12 µA to 500 µA. For gate currents in the 10 m..

FeaturesTwo Independent, High-Gain, Frequency Compensated Op-AmpsSupply Voltage: 3V to 30VInput Offset Voltage: 3 mVInput Offset Current: 2 nAInput Bias Current: 20 nALow Supply Current Drain: 0.7mA..

Features of TN2015H66S 20A 600V SCRGate Turn-On Voltage (Vgt): 1.5VPeak Off-State Voltage(Vdrm): 600VOn-State Current (Itrms): 20.0AGate Current (Igt) : 30mATypical Voltage Change over Time (dV/dT) : 425V/µs..

Features of S6012L 15A 600V SCR :Gate Turn-On Voltage (Vgt): 1.5VPeak Off-State Voltage(Vdrm): 600VOn-State Current (Itrms): 15.0AGate Current (Igt): 30mATypical Voltage Change over Time (dV/dT): 425V/µsS6012L 15A 600V SCR..