Relay Switch and Electronic Module
Showing 25–48 of 91 resultsSorted by price: low to high
-
Relay Switch and Electronic Module
5V Dual Channel Relay Module with Optocoupler
Product Highlights
- Low Level Trigger Relay Module
- Two separate LEDs for On/Off indication of the Relay.
- Triggering input voltage 3.3V ? 5V
- Two separate LEDs for On/Off indication of the Relay
- Triggering input voltage 3.3V ? 5V 4)
- Back EMF protection
- Back EMF protection 2 LEDs to indicate when relays are ON.
- Works with logic level signals from 3.3V or 5V devices
- Opto isolation circuitry
- Module with diode current protection, short response time
- AC Control Voltage: 250V @max.10A
- DC Control Voltage: 30V @max. 10A
SKU: RM015143 -
-
Relay Switch and Electronic Module
SCM TTL to RS485 Module, 485 to Serial UART
Product Highlights:
- Has a 120 ohm termination resistors, shorted R0to enable the termination resistor.
- Support multi-machine communication, allowing access at up to 128 devices on the bus
- The module can be hot swapped, the signal does not appear dead phenomenon.
- A large area of copper to prevent interference.
- Compatible with 3.3V and 5.0V power supply.
- Compatible with 3.3V and 5.0V signal.
SKU: RM018093 -
-
-
Relay Switch and Electronic Module
USB to TTL(Rx, Tx) Converter
Product Highlights
- Fully compliant with USB Specification v1.1 and USB CDC v1.1.
- Supports automatic handshake mode.
- Supports Remote wake-up and power management .
- 256-bytes buffer each for upstream and downstream data flow .
- Supports default ROM or external EEPROM for device configuration .
- On-chip USB transceiver .
- On-chip crystal oscillator running at 12MHz .
SKU: RM000010 -
-
Relay Switch and Electronic Module
I2C Module For 16X2 LCD for Arduino/Robotics
Product Highlights:
- Supply voltage: 5V
- The backlight and contrast is adjusted by potentiometer
- Come with 2 IIC interface, which can be connected by Dupont Line or IIC dedicated cable
- Compatible for 1602 LCD
- This is another great IIC/I2C/TWI/SPI Serial Interface
- With this I2C interface module, you will be able to realize data display via only 2 wires.
- If you already has I2C devices in your project, this LCD module actually cost no more resources at all.
- It is fantastic based project
SKU: RM001429
