Electronic Module
Showing 49–72 of 212 resultsSorted by price: low to high
-
-
Relay Switch and Electronic Module
SCM TTL to RS485 Module, 485 to Serial UART
Product Highlights:
- Has a 120 ohm termination resistors, shorted R0to enable the termination resistor.
- Support multi-machine communication, allowing access at up to 128 devices on the bus
- The module can be hot swapped, the signal does not appear dead phenomenon.
- A large area of copper to prevent interference.
- Compatible with 3.3V and 5.0V power supply.
- Compatible with 3.3V and 5.0V signal.
SKU: RM018093 -
-
-
Relay Switch and Electronic Module
USB to TTL(Rx, Tx) Converter
Product Highlights
- Fully compliant with USB Specification v1.1 and USB CDC v1.1.
- Supports automatic handshake mode.
- Supports Remote wake-up and power management .
- 256-bytes buffer each for upstream and downstream data flow .
- Supports default ROM or external EEPROM for device configuration .
- On-chip USB transceiver .
- On-chip crystal oscillator running at 12MHz .
SKU: RM000010 -
-
Relay Switch and Electronic Module
I2C Module For 16X2 LCD for Arduino/Robotics
Product Highlights:
- Supply voltage: 5V
- The backlight and contrast is adjusted by potentiometer
- Come with 2 IIC interface, which can be connected by Dupont Line or IIC dedicated cable
- Compatible for 1602 LCD
- This is another great IIC/I2C/TWI/SPI Serial Interface
- With this I2C interface module, you will be able to realize data display via only 2 wires.
- If you already has I2C devices in your project, this LCD module actually cost no more resources at all.
- It is fantastic based project
SKU: RM001429 -
Buck Converter Step-Down
DC to DC 6-24V to 5V USB Output Step Down Power Charger with Adjustable Buck Converter
-12%
Buck Converter Step-DownDC to DC 6-24V to 5V USB Output Step Down Power Charger with Adjustable Buck Converter
Product Highlights :
- Non-isolated buck module (BUCK) synchronous rectification
- Maximum Output Current: 3A MAX
- Conversion efficiency: can up to 97.5% (6.5V step down to 5V 0.7A) (after short reverse protection and fuses test value)
- Switch frequency: 500KHz
- Output Ripple: 10mV around (12V to 5V3A) 20M bandwidth
- Output indicator: Output voltage indicator is red
- Operating temperature: Industrial grade (-40 to + 85 ) (the higher the ambient temperature, the lower the output power)
- Output overvoltage protection: Yes, input 1.5A fuse, output 5V have 300W TVS tube clamp protection.
- Flat copper inductor, improve conversion efficiency
- With output overvoltage protection. There is 1.5A fuse, output 5V have 300W TVS tube protect your USB device
- Using the latest USB identification circuit, perfectly compatible with IPHONE, the most of Android phones, IPAD etc.
- High-quality USB port
- Output voltage indicator (RED)
- Small size, Compact Size
- Input with reverse polarity protection diode, will not damage when input connect incorrectly
- Ultra-low static current, 0.85 mA only. Do not need to add switch when connected to the car battery, can be connected to car cigarette lighter cable or ACC power supply cable
SKU: RM006355
