Load Pressure Flow and Vibration Sensor

Product Highlights

1. Using SW-420 normally closed type vibration sensor
2. Comparator output, clean signal, good waveform, strong driving ability 15mA
3. Operating voltage 3.3V-5V
4. Output format: digital switching output (0 and 1)
5. Using a wide voltage LM393 comparator
6. With bolt holes for easy installation

Product Highlights 

• The LM393, use of the wide voltage comparator
• Provide both digital and analog output
• Output LED indicator
• Compatible with Arduino
• TTL Compatible

Product Highlights

• Small Module.
• Very easy to use.
• Glass Length:  14mm
• Glass Diameter:  2mm
• Total Length:  45mm
• Max. Switching Voltage: 300 VDC
• Min. Breakdown Voltage: 150 VDC
• Max. Contact Rating:  10W
• Max. Switching Current: 0.55 A
• Max. Operate time:  0.45 ms

Product Highlights:

• Working Voltage: DC 3-5V
• Sensor Type: Simulation
• Detection Area: 40 mm x 16 mm
• Manufacturing Process: FR4 double spray tin
• Fixed Hole Size: 3.2 mm
• Humanized Design: Half moon sag nonskid treatment
• Working Temperature: 10 ?C to 30 ?C
• Work Humidity: 10% to 90% without condensation
• Size: 65 mm x 20 mm x 8 mm

Product Highlights:

• This device is really easy to use.
• 1.8V to 3.6V Supply Voltage.
• Low power consumption – 0.5uA at 1Hz.
• I2C interface.
• Max I2C Speed: 3.5Mhz.
• Very low noise – up to 0.02hPa (17cm).
• Full calibrated.

Product Highlights:

1. Output Sensitivity: 1.0 ? 0.1 mV / V.
2. Two selectable differential input channels.
3. On-chip active low noise PGA with the selectable gain of 32, 64 and 128.
4. On-chip oscillator requiring no external component with optional external crystal.
5. On-chip power-on-reset.
6. Measurement Resolution: 24 bit.

Product Highlights

1. Operating Voltage: 5VDC.
2. Current: 30mA (MAX).
3. Operating temperature: -30 ? C to 80 ? C.
4. Compatible with Arduino, Raspberry Pi, AVR, PIC, etc.
5. Measuring Range: 0 ~ 1000 NTU.

Product Highlights

• Hysteresis/noise neglectible3).
• Resistance is function of radius of curvature, not angle at one point.
• High temperature and humidity-tolerance.
• Relatively low cost.
• Customizable (coatings, laminating materials).