Does your 3D printer make too much noise?

An unpleasant sounding 3D printer is merely an annoyance to the operator and also to the peoples who are in the room. This is endurable when compared with the cost of the beautiful outcome of the 3D printer. But, when the outcome itself is affected by the noise effect of Stepper Motors, then such a thing is unavoidable.

Don’t worry!! We have this Vibration Damper or one can say a Shock Absorber for your NEMA 17 Stepper Motor, the solution to your noise problem. The installation also is very simple and requires only a few minutes of disassembly and assembly.

The Stepper Motors can produce sound waves at certain frequencies, this effect is undesirable and if a 3D printer is made of sheet metal or wood this noise gets amplified.

You can make use of this Nema17 Stepper Motor Shock Absorber / Vibration Damper to avoid this noise effect. Connect this rubber barrier between the motor and the 3D printer frame. This will eliminate the vibrations produced by the stepper motor right before it reaches the 3D printer frame.

The damper has two sides: non-threaded holes for stepper motor mounting, and threaded mounting holes for the printer-side. This is a very good device to reduce the sound generated by your 3D printers.

Features :

1. Useful in reducing shocks.
2. Effective for 3D printers
3. This will help to reduce resonance.