Search

The L298 dual full-bridge motor driver board for Arduino/Raspberry-pi,uses double H driver ic L298 which an integrated monolithic circuit in a 15 - lead Multi watt and Power SO20 packages. It is a high voltage, high current dual full-bridge driver designed to accept standard TTL logic levels and dri..

Dual H-Bridge Power Transistor Motor Driver Arduino Board is a simple motor driver used to drive high power dc motor which is both the combination of two NPN & PNP (TIP-122 & TIP-127) transistors to operate dual motor at a time in bidirectional.Features of Dual H-Bridge Power Transistor Moto..

The Motor driver is based on the diode basis, which is a Half-bridge driver designed to drive inductive loads such as relays, solenoids, DC and stepping motors. It lets you drive two DC motors with your Robomart Arduino board, controlling the speed and direction of each one independently. You can al..

The ULN2803 Stepper Motor driver is ideal for driving a stepper motor through Arduino or any other platform.Specification of ULN2803 Stepper Motor Driver Board:500mA drain per channel.Up to 50V Output Voltage.Output Clamp Diodes.Medium Power Stepper Motor Application.Applications of ULN2803 Stepper ..

ROBOMART makes a low-cost relay board shown above that contains both the relay and the required driver circuit built using a discrete transistor. The relay coils on this relay require around 6VDC. It is easier to drive relays like this that use a lower coil voltage. The relay can switch up to 220VAC..

The L293D is a Monolithic Integrated, High Voltage, High Current, 4-Channel Driver module. Basically you can use DC Motors and Power Supplies of up To 36 Volts, That’s Some Pretty Big Motors and the chip can supply a maximum current Of 600Ma Per Channel, The L293D Chip Is Also What’s known as a type..

The L298 Stepper Motor Driver Board Module For Arduino/Raspberry-pi/Robotics, using ST L298 chip can directly drive two DC motor, and provides a 5V output interface, support 5v and 3.3V MCU control, you can easily control the DC motor speed and direction, you can also control the 2-phase stepper mot..

ROBOMART makes a low-cost relay board shown above that contains both the relay and the required driver circuit built using a discrete transistor. The relay coils on this relay require around 6VDC. It is easier to drive relays like this that use a lower coil voltage. The relay can switch up to 220VAC..